Anest Iwata Premium Spray Gun for Ceramic Glaze

About

7085-AIP
Anest Iwata Premium Spray Gun for Ceramic Glaze 

• Supplied with 250ml cup and standard nozzle for general glaze coverage.
• This gun has been tested with between 1-1.5 bar compressor pressure.
• You will need a compressor that delivers a minimum of 2.12cfm (60Nl/min) delivered at 1 bar minimum.
• Offers enhanced decorative options by adjusting the nozzle, such as spatter pattern
• This gun has been tested with both powdered glaze mixed to a specific gravity of around 1.6, and with thinned-down brush on glaze.
• If using with thinned brush-on glaze be aware that gums and binders slow the drying time. Build coats gradually and wait a short time between coats to ensure each dries before the next is applied.
• Ensure correct PPE is used when spraying glazes (spray booth, P3 mask, suitable protective clothing)

Pressure regulator sold separately (you may not need this if your home compressor already has one)
7085-REG Pressure Regulator >

Replacement parts are available as follows:
7085-AIP-1 Nozzle Set >
7085-AIP-2 Needle Set >
7085-AIP-3 Needle Packing Cartridge >

Contact our Technical team for advice.

Collections

• Spray Equipment

Ask a Technical Question